Chassis SC745 User's Manual Rear Connectors and Pin Definitions #1. CPLD Chip The CPLD is an enclosure management chip that supports the SGPIO and LED management. #2. JTAG Connector The JTAG connector, designated J16, is used for diagnostic purposes. This connector should not be used as it is for internal testing only. #3. – 4. SAS3 Ports The SAS3 ports are used to connect the SAS3 drive cables. The 2 ports are designated JSM0, for drives at SAS #0-#3, and JSM1, for drives at SAS #4-#7 (see section 2-4 for SAS drive locations). Each port is also compatible with SATA drives. However, mixing SAS3 and SATA drives in the same enclosure is not recommended. #5. – #7.
Backplane Main Power Connectors The 4-pin connectors, designated JPW1, JPW2, and JPW3, provide power to the backplane. See the table on the right for pin definitions. 70 Backplane Main Power 4-Pin Connector Pin# Definition 1 +12V 2 and 3 Ground 4 +5V