Chapter 5: Chassis Setup and Maintenance Chapter 5 Chassis Setup and Maintenance 5-1 Overview This chapter covers the steps required to install components and perform mainte- nance on the SC813M chassis. The only tool you will need to install components and perform maintenance is a Phillips screwdriver, and under certain circumstances, a hex wrench. Print this page to use as a reference while setting up your chassis. 5-2 Installation Procedures and General Maintenance The following sections will provide you with information on installing components and performing general mainenance on the system.
Installation Procedures Removing the Chassis Cover Installing Hard Drives Installing the DVD-ROM Drive Installing the Motherboard Installing the I/O Shield Permanent and Optional Standoffs Installing Expansion Cards Installing the Air Shroud Checking the Airflow General Maintenance System Fans Power Supply Removing the Backplane Installing the Backplane Review the warnings and precautions listed in the manual before setting up or servic- ing this chassis. These include information in Chapter 2 Standardized Warning State- ments for AC/DC Systems and the warning/precautions listed in the setup instructions. 5-1