Supermicro SC813M — 5-4 Installing Hard Drives

SC813M Chassis Manual Chapter 5: Chassis Setup and Maintenance 5-3 Removing the Chassis Cover 5-4 Installing Hard Drives 1 4 2 3 1 2 2 Figure 5-1: Removing the Chassis Cover Removing the Chassis Cover the Chassis Cover 1 1. Power down the system and unplug the power cord from the rear of the power supply. Figure 5-2: Removing Hard Drive Carrier The SC813M supports four hot-swappable 3.5" hard drives. Only SAS or SATA enterprise level hard drives are recommended. The hard drives in your chassis may look slightly different than the ones shown in this manual. 2. Simultaneously press both release tabs. 3. Slide the cover back toward the rear of the chassis. 4.

Lift the cover upwards and off of the chassis. Removing Hard Drive Carriers from the Chassis 1. Press the release button on the drive carrier. This extends the drive bay handle. Warning: Except for short periods of time, do NOT operate the server without the cover in place. The chassis cover must be in place to allow proper airflow and prevent overheating. 2. Use the handle to pull the drive out of the chassis. 5-2 5-3