SC813M Chassis Manual Chapter 5: Chassis Setup and Maintenance Drive Carrier Dummy Drive SAS/SATA Hard Drive 1 4 Figure 5-3: Chassis Drive Carrier The drives are mounted in drive carriers to simplify their installation and removal from the chassis. These carriers also help promote proper airflow for the drive bays. The hard drives used in your chassis may vary slightly from those illustrated in this manual. 1 4 Drive Carrier Figure 5-5: Removing the Hard Drive From the Carrier Warning: Except for short periods of time while swapping hard drives, do not oper- ate the chassis without the drive carriers. 1.
Install a new drive into the carrier with the printed circuit board side facing down so that the mounting holes align with those in the carrier. 1 1 2. Secure the hard drive by tightening all six screws. 3. Replace the drive tray into the chassis. Make sure the close the drive carrier handle. 1 1 Figure 5-4: Removing a Dummy Drive from the Carrier Installing a Hard Drive to the Hard Drive Carrier 1. Remove the two screws securing the dummy drive to the carrier. 2. Remove the dummy drive from the carrier. 5-4 5-5