SC813M Chassis Manual Chapter 5: Chassis Setup and Maintenance 5-5 Installing the DVD Drive 5-6 Installing the Motherboard Installing the I/O Shield The I/O shield holds the motherboard ports in place. Install the I/O shield before installing the motherboard. If the motherboard you purchased did not include a standard I/O shield, contact the motherboard vendor for a compatible shield. 1 B Installing the I/O Shield 1 A 1. Review the documentation that came with your motherboard. Become familiar with component placement, requirements, and precautions. 2. Power down the system and unplug the power cord from the rear of the power supply. Open the chassis cover as described in Section 5-3.
1 3 1 D 1 C 3. With the illustrations facing outward, place the shield into the space provided at the rear of the chassis as illustrated below. 4. Replace the chassis cover, plug the power cord into the rear of the power supply and power up the system. Figure 5-6: Installing the DVD Drive SC813M chassis models include space for one optional DVD drive. Installing the DVD Drive I/O Shield 1. Power down the system and unplug the power cord from the rear of the power supply. Open the chassis cover as described in Section 5-3. 2. Secure the left rail (A) to the left side of the DVD drive using two screws (B). 3. Attach the right rail (C) to the right side of the DVD drive using two screws (D). 4.
Carefully slide the DVD drive and into the chassis. 5. Plug the power cord into the power supply and power up the system. Figure 5-7: Installing the I/O Shield 5-6 5-7