Supermicro SC813M — Motherboard Installation

SC813M Chassis Manual Chapter 5: Chassis Setup and Maintenance Motherboard Installation Installing the Motherboard 1. Review the documentation that came with your motherboard. Become familiar with component placement, requirements, precautions, and cable connec- tions. 2. Power down the system and unplug the power cord from the rear of the power supply. Open the chassis cover as described in Section 5-3. 3. As required by your motherboard, install standoffs in any areas that do not have a permanent standoff. To do this: a. Place a hexagonal standoff screw through the bottom the chassis. b. Secure the screw with the hexagon nut (rounded side up). 4.

Lay the motherboard on the chassis aligning the permanent and optional standoffs Chassis Standoffs 5. Secure the motherboard to the chassis using the rounded, Phillips head screws. Do not exceed eight pounds of torque when tightening the screws. 6. Secure the CPU(s), heatsinks, and other components to the motherboard as described in the motherboard documentation. Figure 5-8: Chassis Standoffs 7. Connect the cables between the motherboard, backplane, chassis, front pan- el, and power supply, as needed. Also, the fans may be temporarily removed to allow access to the backplane ports.

Permanent and Optional Standoffs Standoffs prevent short circuits by securing space between the motherboard and the chassis surface. The SC813M chassis includes permanent standoffs in locations used by most motherboards. These standoffs accept the rounded Phillips head screws included in the SC813M accessories packaging. 8. Replace the chassis cover, plug the power cord into the rear of the power supply and power up the system. Some motherboards require additional screws for heatsinks, general components and/or non-standard methods to secure them. Optional standoffs are included for these motherboards.

To use an optional standoff, you must place the hexagonal screw through the bottom the chassis and secure the screw with the hexagon nut (rounded side up). Compare the mounting holes in the motherboard to those in the chassis and add or remove standoffs as needed. 5-8 5-9 Figure 5-9: Installing the Motherboard