SC813M Chassis Manual Chapter 5: Chassis Setup and Maintenance Installing Expansion Cards 5-7 Installing the Air Shroud Expansion Card Plugs into the Riser Card Here PCI Slot Bracket Riser Card Bracket Riser Card Bracket Screw Riser Card Figure 5-10: Expansion Card, Riser Card, Bracket and PCI Slot Cover Installing an Expansion Card 1. Confirm that you have the correct riser card for your chassis model and the add-on card includes a standard bracket. Figure 5-11: Air Shroud Installation (Optional) 2. Power down the system and unplug the power cord from the rear of the power supply. Open the chassis cover as described in Section 5-3.
The optional air shroud concentrates airflow to maximize fan efficiency. The SC813M chassis air shroud is easily installed in the chassis and requires no screws for installation. 3. Install the riser card by sliding card into the appropriate slot in the mother- board. For more information, see the installation instructions that came with your motherboard and riser card. Installing the Air Shroud 1. Power down the system and unplug the power cord from the rear of the power supply. Open the chassis cover as described in Section 5-3. Lay the chassis on a flat, stable surface and remove the chassis cover. 4. Choose the PCI slot in which to place the expansion card. 5.
Slide the PCI slot cover sideways. 2. If necessary, move any cables that interfere with the air shroud placement. 6. From inside the chassis, remove the PCI slot cover. 3. Place the air shroud in the chassis. The air shroud fits behind the bank of six fans in the fan rack. Slide the air shroud into the grooves just behind the fan rack. 7. Plug the expansion card into the riser card and fit the expansion card bracket into the PCI slot. 4. Replace the chassis cover, plug the power cord into the rear of the power supply and power up the system. 8. Secure the expansion card by closing the PCI slot lever. 9. Connect cables to the expansion card as necessary. 10.
Replace the chassis cover, plug the power cord into the rear of the power supply and power up the system. 5-10 5-11