SC813M Chassis Manual Chapter 5: Chassis Setup and Maintenance 5-8 Checking the Airflow 5-9 System Fans Checking the Server's Airflow Depending upon the model, the SC813M chassis includes three or four heavy- duty fans with open slots for two or three additional fans to provide cooling for the chassis. These fans circulate air through the chassis as a means of lowering the chassis internal temperature. 1. Make sure there are no objects to obstruct airflow in and out of the server. 2. Do not operate the server without drives or drive carriers in the drive bays. Use only recommended server parts. Replacing a System Fan 3.
Make sure no wires or foreign objects obstruct airflow through the chassis. Pull all excess cabling out of the airflow path or use shorter cables. 1. If necessary, open the chassis as described in Section 5-3 while the power is running to determine which fan requires changing. (Never run the server for an extended period of time with the chassis open.) The control panel LEDs inform you of system status. See “Chapter 4: System Interface” for details on the LEDs and the control panel buttons. 2. Power down the system and unplug the power cord from the rear of the power supply. If not already open, open the chassis cover as described in Section 5-3. Installation Complete 3.
Remove the failed fan's cable from the connector on the motherboard. In most cases, the chassis power supply and fans are pre-installed. If you need to install fans or a power supply, continue to the following sections of this chapter. If the chassis will be installed into a rack, skip to the next chapter for rack installation instructions. 4. Gently pull upward to remove a failed fan from the housing. 5. Place the new fan into the vacant space in the housing. Make sure that the arrows on the sides of the fan (indicating air direction) point in the same direction as the arrows on the other fans. 6. Plug the fan's cable into the connector on the motherboard. 7.
Plug the power cord into the rear of the power supply, power up the system and check that the fan is working properly before replacing the top cover. Figure 5-12: Installing the Fan into the Fan Tray 5-12 5-13