SC813M Chassis Manual Chapter 5: Chassis Setup and Maintenance 5-11 Removing the Backplane 5-12 Installing the Backplane The SC813M chassis backplane is located behind the hard drives and in front of the front system fans. In order to change jumper settings on the backplane, it may be necessary to remove the backplane from the chassis. Installing the Backplane into the Chassis 1. Power down the system and unplug the power cord from the rear of the power supply. Open the chassis cover as described in Section 5-3. Lay the chassis on a flat, stable surface and remove the chassis cover. Removing the Backplane from the Chassis 1.
Power down the system and unplug the power cord from the rear of the power supply. Open the chassis cover as described in Section 5-3. Lay the chassis on a flat, stable surface and remove the chassis cover. 2. Lower the backplane into the chassis sliding it into the clips on the floor of the chassis and aligning the mounting holes in the backplane, with the mounting holes in the chassis. 2. Disconnect the cabling to the backplane. 3. Secure the backplane to the chassis using the two screws provided. 3. Remove the two upper screws at the top of the backplane, indicated by the arrows below. 4. Connect the wiring to the backplane. 4. Lift the backplane up and out of the chassis. 5.
Replace the chassis cover, plug the power cord into the rear of the power supply and power up the system. 1 2 3 1 1 4 Figure 5-15: Removing the Screws at the Top of the Backplane Figure 5-16: Installing the Backplane 5-16 5-17