SC813M Chassis Manual Appendix B: BPN-SAS-815TQ Backplane Specifications B-3 An Important Note to Users B-5 Front Connector and Settings All images and layouts shown in this user's guide are based upon the latest PCB revision available at the time of publishing. The card you have received may or may not look exactly the same as the graphics shown in this manual. 1. Backplane Main Power Connectors The 4-pin connector designated JP10 provides power to the backplane. See the table on the right for pin definitions.
B-4 Front Connectors 1 3 6 JP10 +5V GND GND +12V REV 1.00 SAS815TQ S UPER R #3 #0 J8 +5V +12V +5V +12V J9 J10 JP26 JP47 JTAG UPGRADE JP29:9071 RST JP18:BUZZER RESET #2 JP46 5 4 J7 R144 JP29 #1 J6 J5 JP18 D3 JP42 JP33 JP34 JP40 JP51 JP44 SIDEBAND 2 I C ACT IN MH2 M46 M9 M15 8 2. CD-ROM/DVD-ROM 4-Pin Connectors 2 2 7 ACT0 ACT1 ACT2 ACT3 The 4-pin connectors, designated J9 and J10, provide power to the peripheral drives. See the table on the right for pin definitions. Figure B-1: Front Connectors Front Connectors 1. Power connectors (4-pin) JP10 3. - 4. JTAG Connector and Upgrade Con- nector 2.
CD-ROM/ peripheral drive power J9 and J10 The JTAG connector, designated JP47, and the Upgrade connector, designated JP46, are for diagnostic purposes. These connectors should be used by a certified and experienced technician. 3. JTAG JP47 4. Upgrade pin JP46 5. MG9071 chip 6. Sideband JP51 7. I 2 C connector JP44 5. MG9071 Chip The MG9071 is an enclosure management chip that supports the SES-2 controller and SES-2 protocols.
SAS/SATA Ports 10 12 11 REV 1.00 SAS815TQ S UPER R JTAG UPGRADE JP29:9071 RST JP18:BUZZER RESET JP46 R144 JP29 JP18 JP42 JP33 JP34 9 JP40 JP51 MH2 M46 M9 M15 JP10 +5V GND GND +12V #3 #0 J8 +5V +12V +5V +12V J9 J10 JP26 JP47 #2 J7 #1 J6 J5 D3 JP44 SIDEBAND 2 I C ACT0 ACT1 ACT2 ACT3 ACT IN Figure B-2: SAS Ports B-2 B-3 Backplane Main Power 4-Pin Connector Pin# Definition 1 +12V 2 and 3 Ground 4 +5V CD-ROM/ DVD-ROM Power 4-Pin Connector Pin# Definition 1 +5V 2 and 3 Ground 4 +12V