Supermicro SC813M — Appendix C BPN-SAS-815TQ Backplane Specifications

SC813M Chassis Manual Appendix B: BPN-SAS-815TQ Backplane Specifications 6. Sideband Headers JP29 B-6 Front Jumper Locations Settings JP18 right for pin definitions. REV 1.00 SAS815TQ S UPER R JTAG UPGRADE JP29:9071 RST JP18:BUZZER RESET JP46 R144 JP29 JP18 JP42 JP33 JP34 JP40 JP51 MH2 M46 M9 M15 JP10 +5V GND GND +12V #3 #0 J8 +5V +12V +5V +12V J9 J10 JP26 JP47 #2 J7 #1 J6 J5 D3 JP44 SIDEBAND 2 I C ACT0 ACT1 ACT2 ACT3 ACT IN JP40 JP40 JP51 JP33 JP34 JP42 JP33 JP34 JP42 JP50 2 I C #0 J5 SIDEBAND MH2 M46 M9 M15 7. I 2 C Connectors JP44 JP26 ACT0 ACT1 ACT2 ACT3 ACT IN The I 2 C connectors, designated JP44, are used to monitor HDD activity and status.

See the table on the right for pin definitions. Figure B-3: SAS/SATA Ports Explanation of Jumpers 3 2 1 To modify the operation of the backplane, jumpers can be used to choose between optional settings. Jumpers create shorts between two pins to change the function of the connector. Pin 1 is identified with a square solder pad on the printed circuit board. Note: On two pin jumpers, "Closed" means the jumper is on and "Open" means the jumper is off the pins. Connector Pins 8. Activity LED Header The activity LED header, designated JP26, is used to indicate the activity status of each SAS drive. For the Activity LED Header to work properly, connect using a 10-pin LED cable.

Jumper Setting 3 2 1 9. - 12. SAS Ports The SAS ports are used to connect the SAS drive cables. The four ports are designated #0 - #4. Each port is also compatible with SATA drives. B-4 B-5 e designated JP51.

y, you must connect See the table to the Sideband Headers Pin # Definition Pin # Definition 2 Backplane 1 Controller Addressing (SB5) ID (SB6) 4 Reset (SB4) 3 GND (SB2) 6 GND (SB3) 5 SDA (SB1) 8 Backplane ID (SB7) 7 SCL (SB0) 10 No Connec- tion 9 No Connec- tion I2C Connector Pin Definitions Pin# Definition 1 Data 2 Ground 3 Clock 4 No Connection SAS Activity LED Header Pin Definitions Pin # Definition Pin # Definition 1 ACT IN#0 6 ACT IN#4 2 ACT IN#1 7 ACT IN#5 3 ACT IN#2 8 ACT IN#6 4 ACT IN#3 9 ACT IN#7 5 Ground 10 Empty Jumper Settings Jumper Jumper Settings Note JP18 Open: Enabled Closed: Disabled Buzzer reset JP29 Open: Default Closed: Reset MG 9071 chip reset