Supermicro SC815 — 4-3 Control Panel LEDs

SC815 Chassis Manual Chapter 4: System Interface 4-3 Control Panel LEDs 4-2 Control Panel Buttons There may be up to three push-buttons located on the front of the chassis. These are (in order from left to right) a reset button and a power on/off button. The control panel located on the front of the SC815 chassis has five LEDs. These LEDs provide you with critical information related to different parts of the system. This section explains what each LED indicates when illuminated and any correc- tive action you may need to take. Your chassis model will have some, but not all of the LEDs listed. Reset: The reset button is used to reboot the system. Power:

The main power switch is used to apply or remove power from the power supply to the server system. Turning off system power with this button removes the main power but keeps standby power supplied to the system. Therefore, you must unplug system before servicing. Universal Information LED: The Universal Information LED is used to indated fan failure, power failure, overheat condition, or to identify the unit within a large rack installation. The feature requires a motherboard that supports the Universal Information LED. When this LED blinks red quickly, it indicates a fan failure and when blinking red slowly a power failure. This LED will be blue when used for UID (Unit Identifier).

When on continuously red, it indicates an overheat condition, which may be caused by cables obstructing the airflow in the system or the ambient room temperature being too warm. See the table below for descriptions of the LED states. UID (UB and WB Models Only): SC815 UB and WB chassis models include a UID button. When used with a UID-compatible motherboard, the UID button is used to turn on or off the blue light function of the the U-LED. Once the blue light is activated, the unit can be easily located in very large racks and server banks. Note: Deactivating the UID LED must be performed in the same way it was acti- vated.

(If the UID LED was activated via IPMI, you can only turn the LED off via IPMI and not with the UID button.) 4-2 4-3 Universal Information LED States State Indication Fast Blinking Red (1x/sec) Fan Fail Solid Red CPU Overheat Slow Blinking Red (1x/4 sec) Power Fail Solid Blue Local UID Button Depressed Blinking Blue IPMI-Activated UID