SC815 Chassis Manual Chapter 4: System Interface 4-4 Drive Carrier LEDs Your chassis supports either SAS or SATA, Information LED: SAS/SATA Drives Each SAS/SATA drive carrier has two LEDs. Green: Each Serial ATA drive carrier has a green LED. When illuminated, this green LED (on the front of the SATA drive carrier) indicates drive activity. A connection to the SATA backplane enables this LED to blink on and off when that particular drive is being accessed. Red: The red LED indicates a SAS/SATA drive failure. If one of the SAS/SATA drives fail, you should be notified by your system management software.
4-5 Power Supply LEDs and Overheat Indicators This chassis provides several options which may include hot-swappable, cold- swappable, and redundant power supplies. Some power supplies include an LED in the rear with the following definitions: NIC2: Indicates network activity on GLAN2 when flashing. 450W and 650W Power Supplies NIC1: Indicates network activity on GLAN1 when flashing. HDD: Indicates HDD activity. SAS/SATA drive and/or DVD-ROM drive activity when flashing. Solid Green: When illuminated, the green LED indicates that the power supply is on. Solid Amber:
When illuminated, the amber LED indicates the power supply is plugged in and turned off, or the system is off but in an abnormal state. Blinking Amber: When blinking, this system power supply temperature has reached to 63C. The system automatically power down when the power supply temperature reaches 70C and restarts when the power supply temperature goes below 60C. Power: Indicates power is being supplied to the system's power supply units. This LED should normally be illuminated when the system is operating. 4-4 4-5 Information LED Status Description Solid red An overheat condition has occured. (This may be caused by cable congestion).
Blinking red (1Hz) Fan failure, check for an inoperative fan. Blinking red (0.25Hz) Power failure, check for a non-operational power supply. Solid blue Local UID has been activated. Use this function to locate the server in a rack mount environment. Blinking blue (300 msec) Remote UID is on. Use this function to identify the server from a remote location. 450W and 650W Power Supply LEDs State Indication Solid Green System is on. Solid Amber System is off and plugged in. Blinking Amber Internal temperature has reached 63C and will shut down if the tempertature reaches 70C.