Supermicro SC815 — The Front Bezel (Optional)

SC815 Chassis Manual Chapter 5: Chassis Setup and Maintenance 5-2 Removing the Chassis Cover and Front Bezel 2 4 3 2 Front Bezel Release Knob Bezel pins 1. power supply. Remove both power cords if your system includes a redundant power supply. it to access the drive bays. A filter located within the bezel can be removed for cleaning or replacement. It is recommended that you keep a maintenance log and frequently replace the filter. The filter's condition will affect the airflow throughout the whole system. 2. Press the release tabs to remove the cover from the locked position. Press both tabs at the same time. Removing the Front Bezel 3.

Once the top cover is released from the locked position, slide the cover toward the rear of the chassis. 1. Unlock the bezel lock. 2. Press the release knob to retract the bezel pins 4. Lift the cover off the chassis. 3. Carefully remove the bezel with both hands. Warning: Except for short periods of time, do NOT operate the server without the cover in place. The chassis cover must be in place to allow proper airflow and prevent overheating. 5-2 5-3 Release Tab Figure 5-1. Removing the Chassis Cover ng the Chassis Cover r down the system and remove the power cord from the rear of the