SC815 Chassis Manual Chapter 5: Chassis Setup and Maintenance 5-6 Installing the Air Shroud Installing the Air Shroud 1. Power down the system and remove the power cord from the rear of the power supply. Remove both power cords if your system includes a redundant power supply. Remove the chassis cover as described in Section 5-3. Optional Flap 2. If your motherboard uses between 9 and 16 DIMMS, skip this step. If your motherboard uses 8 DIMMS, you must remove the optional flap. To do so: a. With the fan side facing you, hold the air shroud with your left hand on the main shroud component and right hand on the optional flap. b.
Gently twist with your right hand by lifting the fan side and lowering the other end of the optional flap. 3. Place the air shroud in your chassis with the fan side touching the edge of the fans. Figure 5-12. Air Shroud Front (Fan Side) 4. Reconnect the power cord(s), power up the system and replace the chassis cover. Checking the Airflow in the Chassis Air shrouds concentrate airflow to maximize fan efficiency. The SC815 chassis air shroud does not require screws to set up. 1. Make sure there are no objects to obstruct airflow in and out of the chas- sis. In addition, if you are using a front bezel, make sure the bezel's filter is replaced periodically. 2.
Do not operate the chassis without drive carriers in the drive bays. Use only recommended chassis parts. 3. Make sure no wires or foreign objects obstruct air flow through the chassis. Pull all excess cabling out of the airflow path or use shorter cables. 4. The control panel LEDs inform you of system status. See “Chapter 3: System Interface” for details on the LEDs and the control panel buttons. Figure 5-13. Air Shroud with the Optional Flap Removed 5-12 5-13