SC815 Chassis Manual Chapter 5: Chassis Setup and Maintenance 2. Remove the chassis cover. 3. Install the riser card onto the bracket. Insert the card and bracket into the appropriate slot on the motherboard. Secure the riser bracket to the chassis using screws as illustrated. "W" Model Chassis: Two Full-Height, Full-Length and One Low-Profile PCI Slots Figure 5-11. PCI Card Slot Variations 4. Choose the PCI slot in which to place the add-on card. 5. In that slot, open the PCI slot panel lever and slide the PCI slot panel side- ways. 6. From inside the chassis, remove the PCI slot panel panel. 7.
Slide the add-on card into the riser card and attach the add-on card bracket in place of the PCI slot panel. 8. Secure the add-on card by closing the I/O panel lever. 9. Connect cables to the add-on card if necessary. 5-10 5-11 Expansion Card Setup The SC815 chassis includes PCI slots for expansion cards and expansion cards "C" models (like SC815TQ-600CB) include one full height slot. "W" model chassis include two full-height expansion slots and one low-profile expansion slot. Other models include a full-height, full-length PCI slot and one low-profile PCI slot. Note: You must use a riser card to install expansion cards into any SC815 chassis. Riser cards are sold separately.
For the lat- est compatibility and performance information, visit our website at http://www.supermicro.com. "C" Model Chassis: One Full-Height, Full-Length PCI Slot Riser Card Riser Card Bracket Screws . : Figure 5-12. Chassis with a Riser Card Installing an Expansion Card 1. Confirm that you have the correct riser card for your chassis model and the add-on card includes a standard bracket.