Supermicro SC815 — Permanent and Optional Standoffs

SC815 Chassis Manual Chapter 5: Chassis Setup and Maintenance 5-5 Installing the Motherboard Installing the Motherboard 1. Review the documentation that came with your motherboard. Become famil- iar with component placement, requirements, and precautions. 2. Power down the system and remove the power cord from the rear of the power supply. Remove both power cords if your system includes a redundant power supply. Remove the chassis cover as described in Section 5-3. Open the chassis cover. Permanent Standoffs 3. If necessary, remove the riser card. To do this, remove the two screws hold- ing the card in place and lift the card from the chassis. 4.

As required by your motherboard, install standoffs in any areas that do not have a permanent standoff: A. Place a hexagonal standoff screw through the bottom the chassis. B. Secure the screw with the hexagonal nut (rounded side up). Optional Standoffs 5. Lay the motherboard on the chassis aligning the permanent and optional standoffs 6. Secure the motherboard to the chassis using the rounded, Phillips head screws. Do not exceed eight pounds of torque per square inch, when tighten- ing down the motherboard. Figure 5-9 Chassis Standoffs 7. Secure the CPU(s), heatsinks, and other components to the motherboard, chassis, and/or backplane as needed.

Standoffs prevent short circuits by securing space between the motherboard and the chassis surface. The SC815 chassis includes permanent standoffs in locations used by most motherboards. These standoffs accept the rounded Phillips head screws included in the SC815 accessories packaging. Permanent and Optional Standoffs 8. Reconnect the power cord(s), power up the system and replace the chassis cover. Riser Card Some motherboards require additional screws for heatsinks and/or general compo- nents. Optional standoffs are included for these motherboards.

To use an optional standoff, you must place the hexagonal screw through the bottom the chassis and secure the screw with the hexagonal nut (rounded side up). Figure 5-10. Chassis with a Riser Card ("U" Models Only) 5-8 5-9