Supermicro SC815 — 5-4 Installing the DVD Drive

SC815 Chassis Manual Chapter 5: Chassis Setup and Maintenance 5-4 Installing the DVD Drive SAS/SATA Hard Drive 4 1 B 1 A 4 Drive Tray 1 C Figure 5-6. Removing the Hard Drive From the Carrier 1 3 1 D 3. Install a new drive into the carrier with the printed circuit board side facing down so that the mounting holes align with those in the carrier. Figure 5-8. Installing the DVD Drive 4. Secure the hard drive by tightening all six (6) screws. 5. Replace the drive tray into the chassis. Make sure the close the drive carrier handle. SC815 chassis models include space for one optional DVD drive. Installing the DVD Drive 1.

Power down the system and unplug the power cord from the rear of the power supply. Open the chassis cover as described in Section 5-3. 2. Secure the left rail (A) to the left side of the DVD drive using two screws (B). 3. Attach the right rail (C) to the right side of the DVD drive using two screws (D). 4. Carefully slide the DVD drive and into the chassis. 5 5. Plug the power cord into the power supply and power up the system. Figure 5-7. Replacing the Hard Drive Carrier 5-6 5-7