SC815 Chassis Manual Appendix C BPN-SAS3-815TQ Backplane Specifications C-5 Rear Connector Definitions 7. I 2 C Connectors The I 2 C Connectors, designated JP44, are used to monitor HDD activity and status. 1. Backplane Main Power Connectors The 4-pin connectors, designated JP10 provide power to the backplane. 2. Peripheral Drive 4-Pin Connectors The 4-pin connectors, designated J9 and J10, provide power to DVD or other peripheral drives. 8. Activity LED Header The Activity LED header, designated JP26, is used to indicate the activity status of each SAS drive. To enable, connect using a 10-pin LED cable. 3. - 4.
JTAG Connector and Upgrade Connector The JTAG connector, designated JP47, and the upgrade connector, designated JP46, are for diagnostic purposes. These connectors should be used by a certified and experienced technician. 9. - 12. SAS Ports The SAS ports are used to connect cables to SAS3 drives, enabling 12Gbps speeds. The four ports are designated #0 - #4. Each port is also compatible with SATA drives. 5. MG9071 Chip The MG9071 is an enclosure management chip that supports the SES-2 controller and SES-2 protocols. 6. Sideband Headers The sideband header is designated JP51. For SES-2 to work properly, you must connect an 8-pin sideband cable.
C-4 C-5 I2C Connector (JP44) Pin# Definition 1 Data 2 Ground 3 Clock 4 No Connection Main Power (JP10) Pin# Definition 1 +12V 2 and 3 Ground 4 +5V Peripheral Drive Power (J9 and J10) Pin# Definition 1 +5V 2 and 3 Ground 4 +12V SAS Activity LED Header (JP26) Pin # Definition Pin # Definition 1 ACT IN#0 6 ACT IN#4 2 ACT IN#1 7 ACT IN#5 3 ACT IN#2 8 ACT IN#6 4 ACT IN#3 9 ACT IN#7 5 Ground 10 Empty Sideband Header (JP51) Pin # Definition Pin # Definition 2 Backplane Addressing (SB5) 1 Controller ID (SB6) 4 Reset (SB4) 3 GND (SB2) 6 GND (SB3) 5 SDA (SB1) 8 Backplane ID (SB7) 7 SCL (SB0) 10 No Connec- tion 9 No Connec- tion