SC815 Chassis Manual Appendix C BPN-SAS3-815TQ Backplane Specifications This backplane can utilize I 2 C or SGPIO. SGPIO is the default mode and can be used without making changes to your jumpers. Use the following settings for I 2 C mode. I 2 C and SGPIO Modes and Jumper Settings REV 1.00 SAS815TQ S UPER JTAG UPGRADE JP29:9071 RST JP18:BUZZER RESET JP18 JP42 JP33 JP34 JP40 JP51 JP10 +5V GND GND +12V R #3 #0 J8 +5V +12V +5V +12V J9 J10 JP26 JP47 #2 JP46 J7 R144 JP29 #1 J6 J5 JP18 D3 JP50 JP44 SIDEBAND 2 I C ACT0 ACT1 ACT2 ACT3 ACT IN MH2 M46 M9 M15 JP50 JP33 JP34 JP42 JP33 JP34 JP40 JP40 JP51 JP42 JP50 2 I C #0 J5 SIDEBAND JP26 Figure C-2.
Rear Jumpers Explanation of Jumpers To modify the operation of the backplane, jumpers can be used to choose between optional settings. Jumpers create shorts between two pins to change the function of the connector. Pin 1 is identified with a square solder pad on the printed circuit board. Note: On two pin jumpers, "Closed" means the jumper is on and "Open" means the jumper is off the pins.
Jumper Setting 3 2 1 General Jumpers JP18 Jumper JP29 C-6 C-7 C-6 Rear Jumpers and Pin Definitions SGPIO Jumpers (Default) Jumper Setting Description JP33 JP34 Pins 1-2 Pins 1-2:ID#0 Controller ID Backplane ID JP40 Closed I2C Reset SD OUT JP42 Pins 1-2 Backplane ID SDIN JP50 Open I2C Reset I2C Jumpers Jumper Setting Description JP33 Pins 2-3 Controller ID JP34 Pins 1-2:ID#0 Backplane ID JP40 Open I2C Reset SD OUT JP42 Pins 2-3 Backplane ID SDIN JP50 Closed I2C Reset 3 2 1 Connector Pins Settings Description Open: Enabled Closed: Disabled Buzzer Reset Open: Default Closed: Reset MG 9071 Chip Reset