SC825 Chassis Manual 1. Review the documentation that came with your motherboard. Become familiar with component placement, requirements, precautions, and cable connec Installing the Motherboard tions. 2. Power down the system and remove the power cords from the rear of the power supply. Open the chassis cover as described in Section 5-3. 3. As required by your motherboard, install standoffs in any areas that do not have a permanent standoff. To do this: A. Place a hexagonal standoff screw through the bottom the chassis. B. Secure the screw with the hexagon nut (rounded side up). 4. Lay the motherboard on the chassis aligning the permanent and optional standoffs 5.
Secure the motherboard to the chassis using the rounded, Phillips head screws. Do not exceed eight pounds of torque when tightening down the motherboard. 6. Secure the CPU(s), heatsinks, and other components to the motherboard as described in the motherboard documentation. 7. Connect the cables between the motherboard, backplane, chassis, front pan el, and power supply, as needed. Also, the fans may be temporarily removed to allow access to the backplane ports. Figure 5-14. Chassis Standoffs 5-14