Super Micro Computer, Inc. SC825 — Appendix B BPN-SAS-825TQ Backplane Specifications

SC825 Chassis Manual B-7 Front Jumper Locations and Pin Definitions JP43 JP18 JP29 JP50 GND GND +12V +5V GND GND +12V +5V GND GND +12V +5V GND GND +12V +5V 1 1 JP36 1 1 ACT_IN ACT_IN #2 2 I C #2 I C 2 SIDEBAND #2 SIDEBAND #2 + + + + + + + + + + + + JP37 JP38 + + + + + + + + + + + + + + + + 1 1 16 16 JP33 32 32 48 BAR CODE REV 2.0 SAS825TQ 48 JP34 REV 2.0 SAS825TQ BAR CODE I C 2 I C 2 #1 #1 JP29:9072 RESET JP29:9072 RESET JP42 JP41 JP40 SIDEBAND #1 SIDEBAND #1 Figure C-3. Front Jumpers Explanation of Jumpers Connector Pins 3 2 1 To modify the operation of the backplane, jumpers can be used to choose between optional settings.

Jumpers create shorts between two pins to change the function of the connector. Pin 1 is identified with a square solder pad on the printed circuit board. Note: On two pin jumpers, "Closed" means the jumper is on and "Open" means Open, jumper off the pins. Jumper Closed, jumper on the pins. 3 2 1 the jumper is off the pins. Setting *The buzzer sound indicates that a condition requiring immediate attention has occurred. The buzzer alarm is triggered by the following conditions: 1. Hard drive failure 2. System temperature over 45є Celsius. B-6 Jumper Settings Jumper Jumper Settings Note JP29 Open (Jumper off the pins): Default Closed (Jumper on the pins):

Reset MG9072 chip reset JP18 Open (Jumper off the pins): Default Closed (Jumper on the pins): Reset Buzzer reset*