SC825M(B) Chassis Manual Expansion Card Setup in UIO/WIO Model Chassis The configuration of the expansion cards in UIO/WIO models will vary, depending upon if a Universal I/O card or WIO card is used: With a UIO card: Up to three full-height, half-length I/O may be used Up to three low-profile PCI slots may be used. With a WIO card: Up to four full-height, half-length PCI slots may be used Up to three low-profile PCI slots may be used. Installing an Expansion Card in a UIO/WIO Model Chassis 1. Confirm that each add on card you are installing includes a standard "L" bracket.
If this is the first expansion card, start by locating the riser card bracket in your chassis accessory bag and one or two riser cards, which are purchased sepa rately. One riser card accommodates the full-height expansion cards and the other accommodates the three low profile expansion cards. 2. Power down the system and remove the power cords from the rear of the power supplies as described in Section 5-2. Remove the chassis cover as described in Section 5-3. 3. Attach the riser card(s) to the riser card bracket using screws. Note that there 4. Insert the riser card(s) into the motherboard expansion slot(s) while aligning the are different cards for the right and left side of the bracket.
riser card bracket with the rear of the chassis. Secure the bracket with screws (Figure 5-16). Figure 5-16. Riser Card Bracket 5-14