Supermicro SC836 — Appendix D SC836B Chassis Specifications

Appendix E: CB3 JBOD Control Board Component and Connector Definitions 1. BMC Chip The Baseboard Management Controller (BMC) chip monitors the physical state of a system and provides communication with the system administrator through an independent connection. 2. SAS2/SAS3 I 2 C Connectors These connectors are designated JP1-JP4 and allow the power board to be connected to up to four SAS2/SAS3 backplanes. 3 and 4. Manufacturing Test Connectors Connectors J3 and FB1 are for Supermicro manufacturing use only. 5. IPMI LAN LED Header This connector is designated JP6 and is used to connect to the LED indicators on the chassis using cable CBL-NTWK-0584 or CBL-NTWK-0587.

Ground UID Link Ground Act 2 1 Ground 6. IPMI LAN Connector The Intelligent Platform Management Interface (IPMI) LAN connector is designated J8 and supports connectivity with a local network using cable CBL- NTWK-0584 or CBL-NTWK-0587. 7. SC847D SAS2 I2C Connectors The backplane connectors are designated J4-J7 and allow the power board to be connected to up to four SC847D expanders. 8. Control Panel Connector This connector is designated JF1 and connects to the control panel on the chassis. See Chapter 3 for additional control panel information.

NMI 19 20 3V3 X ID_UID_SW/3/3V Stby NIC2 Activity NIC1 Activity Red+ (Blue LED Cathode) 3V3 Reset Reset Button 2 1 PWR Power Button E-3 Ground X PWRLED HDD LED NIC1 Link NIC2 Link H/Fan Fail/ L/UID LED) Fail LED Ground Ground