SC836 Chassis Manual 9. PMBus Connector This connector is designated JPI2C1 and connects the power distributor to the Power Management Bus (PMBus). 10. Fan Connectors The fan connectors supply power to the fans and are designated FAN1-FAN10. 11. ATX Power Connector The ATX power connector is designated JPW1. Connectors Jumpers and LED Indicators JP7 SAS2/SAS3: Use JP1-JP4 4 1 JP7 1 2 3 1 3 6 3 2 1 4 3 2 1 4 JP1 FAN1 + 1 4 5 9 3 2 1 4 3 2 1 4 # JP4 JP2 JP3 C131 + J3 LE1 C FB1 1 2 F1 1 2 5 6 10 J2 Q27 Y1 U9 BT1 12 15 17 A 16 19 JP6 6 U7 L7 36 37 48 2-3:DHCP + 1-2:Static IP JP7 13 14 18 1 7 12 13 24 25 MH4 J8 Figure CB3-2.
Connectors and Jumpers Front SAS2/SAS3 and SC847D Jumpers Jumper Description JP7 Pins 1-2: IPMI factory mode, IP 192.168.1.99 Pins 2-3: User mode (static/DHCP) JP5 Pins 1-2: SAS3 enabled Pins 2-3: SAS2 enabled and SC847D When enabling SAS2/SAS3 functionality, use connectors JP1-JP4, and set the JP5 jumper to pins 1-2 (SAS3) or pins 3-4 (SAS2). When an SC847D chassis is being used, use connectors J4-J7 and set the JP5 jumper to pins 2-3.
E-4 MH14 4 4 4 4 4 MH24 FA JPI FAN2 1 FAN31 FAN4 1 FAN5 1 FAN6 1 1 D16 % 1 FAN7 N8 + FAN9 1 U* + FAN10 1 AC U1 C1 U8 C153 4 LE2 U5 20 R C K 10 U12 U3 E 1 2C1 5 13 1 0C4 9 C6 3 U14U17U18 U16 15 97 31 + U11 A A E K R Y U6 C8 J24 12 J5 12J6 12J7 1 Q5 1 Q4 C21 Y2 19 8 78 78 78 7J 21P --325 ::SSAASS23_847D1 JP53 20 JF1 2 MH3 NMI X PWR LEDX NIC1JFX1 OH/FFJP XW 1 RST2 O4 NPWR ON12 Q16 321 JP5 SC847D: Use J4-J7