Supermicro SC836 — Appendix D SC836B Chassis Specifications

SC836 Chassis Manual SC847 JBOD Chassis Cabling for SAS3 I 2 C Use the diagram below to connect the CB3 JBOD control board to the front and rear backplanes in the SC847 JBOD chassis. When enabling SAS2/SAS3 functionality, use connectors JP1-JP4, (see Page E-4) and set the JP5 jumper to pins 1-2 (SAS3) or pins 3-4 (SAS2). When an SC847D chassis is being used, use connectors J4-J7 (see Page E-4) and set the JP5 jumper to pins 2-3. CBL-CDAT-0601 Front Backplane BPN-SAS3- 846EL1/EL2 Connected to the I 2 C Connector (I2C0) CBL-CDAT-0601 CSE-PTJBOD-CB3 Rear Backplane BPN-SAS3-847EL1/EL2 Connected to the Primary I 2 C Connector (SMB) Figure CB3-6.

SAS3 I 2 C Cabling in the SC847 JBOD Chassis E-8 Jumper Settings Jumper Setting JP5 Pins 1-2: SAS3 enabled Pins 2-3: SAS2 enabled and SC847D JP1