Supermicro SC836 — Appendix D SC836B Chassis Specifications

Appendix E: CB3 JBOD Control Board SC847B Chassis Cabling for SAS3 I 2 C Use the diagram below to connect the I 2 C cabling. Ensure that the JP5 jumper on the CB3 power board is cabled correctly according to the figure below. When enabling SAS2/SAS3 functionality, use the connectors on the upper left of the CB3 power board power board (See Page E-4) and set the JP5 jumper as shown in the chart above. When an SC847D chassis is being used, use the connectors along the bottom edge fo the power board (See Page E-4) and set the JP5 jumper as shown in the chart above.

CBL-CDAT-0601 Front Backplane BPN-SAS3- 846EL1/EL2 Connected to the Primary I 2 C Connector (I2C0) CBL-CDAT-0601 CSE-PTJBOD-CB3 Rear Backplane BPN-SAS3-826EL1/EL2 Connected to the Primary I 2 C Connector (I2C4) Figure CB3-7. SAS3 I 2 C Cabling in the SC847B Chassis E-9 Jumper Settings Jumper Setting JP5 Pins 1-2: SAS3 setting (Default) Pins 2-3: SAS2 and SC847D setting JP1 JP3