Supermicro SC836 — Appendix D SC836B Chassis Specifications

SC836 Chassis Manual SC417B Chassis Cabling for SAS3 I 2 C Use the diagram below to connect the I 2 C cabling. Ensure that the JP5 jumper on the CB3 JBOD control board is cabled correctly according to the figure below. When enabling SAS2/SAS3 functionality, use the connectors on the upper left of the CB3 JBOD control board (See Page E-4) and set the JP5 jumper as shown in the chart above. When an SC847D chassis is being used, use the connectors along the bottom edge of the JBOD control board (See Page E-4) and set the JP5 jumper as shown in the chart above.

CBL-CDAT-0601 BPN-SAS3-216EL1/EL2 Connected to the Primary I 2 C Connector (SMB) CBL-CDAT-0601 BPN-SAS3-216EL1/EL2 Connected to the Primary I 2 C Connector (SMB) Figure CB3-8. SAS3 I 2 C Cabling in the SC417B Chassis E-10 Jumper Settings Jumper Setting JP5 Pins 1-2: SAS3 setting (Default) Pins 2-3: SAS2 and SC847D setting JP1 JP2 CBL-CDAT-0601 BPN-SAS3-216EL1/EL2 Connected to the Primary I2C Connector (SMB)