Supermicro SC836 — Appendix D SC836B Chassis Specifications

Appendix E: CB3 JBOD Control Board SC836B Chassis Cabling for SAS3 I 2 C Use the diagram below to connect the I 2 C cabling. Ensure that the JP5 jumper on the CB3 JBOD control board is cabled correctly according to the figure below. When enabling SAS2/SAS3 functionality, use the connectors on the upper left of the CB3 JBOD control board (See Page E-4) and set the JP5 jumper as shown in the chart above. BPN-SAS3-836EL1/EL2 CBL-CDAT-0601 Connect to the primary I2C connector (SMB) JP1 CSE-PTJBOD-CB3 Figure CB3-9. SAS3 I 2 C Cabling in the SC836B Chassis E-11 Jumper Settings Jumper Setting JP5 Pins 1-2: SAS3 setting (Default) Pins 2-3:

SAS2 and SC836B setting A Secondary Expander B C D Primary Expander A B C D