Supermicro SC836 — C-3 BPN-SAS-836A Backplane

SC836 Chassis Manual Front Jumper Locations and Pin Definitions JP84 JP50 JP35 JP61 JP62 JP99 JP100 JP98 JP97 JP63 JP64 Explanation of Jumpers Figure A-2. Front Jumpers To modify the operation of the backplane, jumpers can be used to choose between optional settings. Jumpers create shorts between two pins to change the function of the connector. Pin 1 is identified with a square solder pad on the printed circuit board. Connector Pins 3 2 1 Jumper 3 2 1 Note: On two pin jumpers, "Closed" means the jumper is on and "Open" means the jumper is off the pins. Setting C-6 General Jumper Settings Jumper Jumper Settings Note JP35 Open: Default Closed: Reset MG9072 chip reset #1 JP50 Open:

Default Closed: Reset MG9072 chip reset #2