Appendix C Backplane Specifications The BPN-SAS-836A backplane can use up to four fans. To utilize each fan, both jumpers must be configured as instructed below. Fan Jumper Settings I 2 C and SGPIO Modes and Jumper Settings This backplane can utilize I 2 C or SGPIO. SGPIO is the default mode and can be used without making changes to your jumpers. The following information details which jumpers must be configured to use SGPIO mode or restore your backplane to I 2 C mode. C-7 Fan Jumper Settings Jumper Jumper Settings Note JP61 Closed: With fan (default) Open: No fan Fan#1 enable/disable JP54 Fan#1 connector JP62 Closed: With fan (default) Open:
No fan Fan#2 enable/disable JP56 Fan#2 connector JP63 Closed: With fan (default) Open: No fan Fan#3 enable/disable JP58 Fan#3 connector JP64 Closed: With fan (default) Open: No fan Fan#4 enable/disable JP60 Fan#4 connector JP97 1-2 With fan (default) 2-3 No fan Fan #1 selection for MG907X Monitor JP99 1-2 With fan (default) 2-3 No fan Fan #2 selection for MG907X Monitor JP100 1-2 With fan (default) 2-3 No fan Fan #3 selection for MG907X Monitor JP100 1-2 With fan (default) 2-3 No fan Fan #4 selection for MG907X Monitor SGPIO/I2C Setting Jumper SGPIO Jumper Setting I2C Jumper Setting JP84 1-2 (default) 2-3