Appendix C Backplane Specifications Front Connector and Pin Definitions #1. Activity LED Header The activity LED headers, designated JP26 and JP47, are used to indicate the activity status of each SAS drive. These activity LED headers are used by the host controller for the SATA drives that previously had no activity status output. If using a SAS drive, and for most SATA drives, these activity headers are not required.The Activity LED Header is located on the front panel. For the Activity LED Header to work properly, connect using a 10-pin LED cable. #2. CD-ROM 4-Pin Connectors The 4-pin connectors, designated JP105 and JP106, provide power to the CD-ROM drives.
See the table on the right for pin definitions. #3. MG9072 Chip The MG9072 is an enclosure management chip that supports the SES-2 controller and SES-2 protocols. C-11 SAS Activity LED Header Pin Definitions Pin # Definition Pin # Definition 1 ACT IN#0 6 ACT IN#4 2 ACT IN#1 7 ACT IN#5 3 ACT IN#2 8 ACT IN#6 4 ACT IN#3 9 ACT IN#7 5 Ground 10 Empty SAS Activity LED Header Pin Definitions Pin # Definition Pin # Definition 1 ACT IN#8 6 ACT IN#12 2 ACT IN#9 7 ACT IN#13 3 ACT IN#10 8 ACT IN#14 4 ACT IN#11 9 ACT IN#15 5 Ground 10 Empty CD-ROM/ FDD Power 4-Pin Connector Pin# Definition 1 +5V 2 and 3 Ground 4 +12V