SC846 Chassis Manual 2. Install the fixed hard drive into the hard drive tray using four round head screws (6-32) and two Mylar washers. Mylar Washer Screw 6-32 Fixed Screw 6-32 Screw 6-32 Figure 4-23. Securing the Fixed Hard Drive into the Tray 3. Lower the drive and tray into the chassis, carefully inserting the lower rubber- lined holes onto the pins at the base of the chassis and aligning the upper rubber holes with the holes in the chassis. 4. Use the two drive tray screws with Mylar washers to secure the hard drive and drive tray on the standoff power supply cage. Figure 4-24. Installing the HDD and HDD Tray in the Chassis 4-20