SC846 Chassis Manual 7. - 9. Sideband Headers The sideband headers are designated JP66, JP68, JP75, JP77, JP112, and JP114. For SES-2 to work properly, you must connect an 8-pin sideband cable. See the table to the right for pin definitions. NOTE: SGPIO is the default setting for this backplane. 10. Backplane Main Power Connectors The 4-pin connectors, designated JP10, JP13, JP46, JP48, JP109, and JP110, provide power to the backplane. See the table on the right for pin definitions. 11 - 34. SAS Ports The SAS ports are used to connect the SAS drive cables. The twenty-four ports are desig- nated #0 - #23. Each port is also compatible with SATA drives.
B-6 Sideband Headers Pin # Definition Pin # Definition 2 SGPIO: SDIN I2C: Backplane Addressing (SB5) 1 Controller ID (SB6) 4 SGPIO: SDOUT I2C: Reset (SB4) 3 GND (SB2) 6 GND (SB3) 5 SGPIO: SLOAD I2C:SDA (SB1) 8 Backplane ID (SB7) 7 SGPIO: SCLOCK I2C:SCL (SB0) 10 No Connec- tion 9 No Connection Backplane Main Power 4-Pin Connector Pin# Definition 1 +12V 2 and 3 Ground 4 +5V