SC936 Chassis Manual E-6 Front Connector and Pin Definitions 1. EPP Ports The EPP ports are used for manufacturer's diagnostic purposes only. 2. Primary and Secondary Expander Chips This primary and secondary expander chips allow the backplane to support dual port, cas cading, and failover configurations. 3. Backplane Main Power Connectors The 4-pin connectors, designated PWR1, PWR2, PWR3 AND PWR4, provide power to the backplane. See the table on the right for pin definitions. 4. Fan Connectors The 4-pin connectors, designated Fan1, Fan2, and Fan3, provide power to the fans. See the table on the right for pin definitions. 5. - 10. SAS Ports Primary and secondary SAS ports. 11. - 12.
UART Connectors Primary and secondary UART connectors. No jumper required. Secondary UART connec tor is not present on the BPN-SAS2-936EL1 backplane. 13. - 14. MDIO Connectors Primary and secondary MDIO connectors. For Supermicro internal use only. Secondary MDIO connector is not present on the BPN-SAS2- 936EL1 backplane. 15. - 16. Debug Connectors Primary and secondary debug connectors. For Supermicro internal use only. Secondary debug connector is not present on the BPN- SAS2-936EL1 backplane. E-4 Backplane Main Power 4-Pin Connector Pin# Definition 1 +12V 2 and 3 Ground 4 +5V Fan Connectors Pin# Definition 1 Ground 2 +12V 3 Tachometer 4 No connection