Appendix E: BPN-SAS2-936EL Backplane Specifications E-7 Front Jumper Locations and Pin Definitions SEC_MODE1 BUZZER_ ENB1 SEC_MODE2 BUZZER_ENB1 1 Q3 MH9 + EC5 U18 A C ACT18 SEC_MODE1 SEC_MODE2 MDIO2 3 3 1 4 EXPDBG2 MH5 MH6 MH7 MH8 + C365 + + C366 + + C363 C362 + + EC26 EC27 L2 L1 + EC1 + Q4 + C91 PRI_MODE2 FAN_LED_DISABLE L59 C133 C120 + C128 C76 C67 1 MDIO1 + C119 + + J16 2 1 PRI_MODE1 JP1 1 4 J18 1 1 4 UART_S1 J19 SEC_J2 A 5 20 10 15 25 SEC_J0 R6 EC4 SEC_J1 + EC2 PRI_J2 5 20 10 15 25 28 C134 C132 PRI_J0 PRI_J1 ACT17 A C A C A C 1 FANFAIL_LED_DISABLE A C A C 1 ACTLED1 1 PRI_MODE1 1 U13 3 PRI_I2C1 FAN_MONITOR_DISABLE + U4 E C361 K R Y AE C367 AH + SAS2-936EL2 REV:
1.01 BCA84 WWN BAR CODE U3 1 E 4 UART_P1 K 4 EXPDBG1 R Y AE AH C121 ACTLED1 5V_LED1 OVERHEATFAIL1 FAN_MONITOR 12V_LED1 FANFAIL1 PRI_MODE2 1 MH13 GND GND +12V +5V +5V +12V GND GND EC20 PWR4 + +5V +12V GND GND PWR3 + PWR1 +5V +12V GND GND PWR2 C390 + EC16 + MH12 EC17 + 4 1 + EC11 + EC13 MH10 MH11 + EC8 4 1 EC10 _DISABLE 4 1 + EC9 Figure E-2: Front Jumpers FAN1 EC14 FAN2 FAN3 Explanation of Jumpers 3 2 1 To modify the operation of the backplane, jumpers can be used to choose between optional settings. Jumpers create shorts between two pins to change the function of the connector. Pin 1 is identified with a square solder pad on the printed circuit board. Note:
On two pin jumpers, "Closed" means the jumper is on and "Open" means the jumper is off the pins. Connector Pins Jumper Setting 3 2 1 E-5