Appendix C: BPN-SAS-936A Backplane Specifications C-6 Front Connector and Pin Definitions 1. MG9072 Chip The MG9072 is an enclosure management chip that supports the SES-2 controller and SES-2 protocols. 2. Upgrade Connectors The upgrade connectors are designated JP69, and JP78 are used for manufacturer's diagnos tic purposes only. 3. ACT_IN: The activity LED connectors, designated JP26, and JP47 are used to indicate the activity status of each SAS drive. The activity LED connector is located on the front panel. For the activity LED connector to work properly, connect using a 10-pin LED cable. This is only used when the activity LED is not supported by the hard drive. 4. and 5.
I 2 C Connectors The I 2 C connectors, designated JP37, JP95, JP52, and JP96 are used to monitor HDD activity and status. See the table on the right for pin definitions. C-3 SAS Activity LED Header Pin Definitions Pin # Definition Pin # Definition 1 ACT IN#0 6 ACT IN#4 2 ACT IN#1 7 ACT IN#5 3 ACT IN#2 8 ACT IN#6 4 ACT IN#3 9 ACT IN#7 5 Ground 10 Empty SAS Activity LED Header Pin Definitions Pin # Definition Pin # Definition 1 ACT IN#8 6 ACT IN#12 2 ACT IN#9 7 ACT IN#13 3 ACT IN#10 8 ACT IN#14 4 ACT IN#11 9 ACT IN#15 5 Ground 10 Empty I2C Connector Pin Definitions Pin# Definition 1 Data 2 Ground 3 Clock 4 No Connection