VEICHI — SD700 User Manual 20230516

When the switching condition of the mode switch is set as torque command [factory default], if the torque command exceeds the torque set in Pn132, the speed loop will be switched to P control. The factory torque command value is set to 200%. Speed command Feedback Torque command time Pn132 Pn132 0 time When the switching condition of the mode switch is set as speed command, if the speed command exceeds the speed set in Pn133, the speed loop will be switched to P control. Speed Command Feedback Pn133 time When the switching condition of the mode switch is set as acceleration, if the speed command exceeds the acceleration set in Pn134, the speed loop will be switched to P control.

Speed Command Feedback ACC time Pn134 0 time Pn134 When the switching condition of the mode switch is set as the position deviation, if the position deviation exceeds the value set in Pn135, the speed loop will be switched to P control. This setting is valid only under position control. 140 SD700 Series Servo Technical Manual command PI P PI P I P PI ACC PI P PI P PI