VEICHI — SD700 User Manual 20230516

Note: the definition of above 1 to 34 home position return methods is according to the CANopen protocol CIA402 standards, and is same as the home position return methods given in the CANopen protocol. The following describes the 1 to 34 methods of the home position return. 8.1.1 Home Position Return Trigger The home position return trigger can automatically perform home position return via SI terminal trigger, point trigger, communication trigger and power-on. 8.1.2 Home Position Return SI Terminal Trigger By configuring the universal SI terminal as the home position trigger function HomeTrig, the home position return is triggered. The rising edge of HomTrig could trigger the home return.

The input function definition of SI terminal related to home return is shown in Table 2.1 below: Table 2.1 SI terminal input function definition Select the SI terminal as the home position trigger signal by configuring the general SI terminal function as 0x1C. When the rising edge of this SI terminal is valid, the home position return is triggered. 8.1.3 Home Position Return Automatically Trigger When Power On The home position return function can be configured to automatically find the home position after the servo drive is powered on for the first time by configuring the function code Pn800. The function definition of Pn800 is shown in the figure below: 0:

Stop after home position return 1-x: Jump to the designated segment to run after home position return 0: Do not perform home position return in the first SvOn 1: Perform home position return in the first SvOn Invalid 155 SD700 Series Servo Technical Manual SI Terminal SI Terminal Function Description Name Function Code HomeTrig 0x1C Home position return trigger function (valid on rising edge) HomeReach 0x1D External input home position signal (valid at high level)