VEICHI — SD700 User Manual 20230516

If the current position command segment bit jump mode, the current position command segment immediately jumps to the position command segment of the specified segment number, and the position command of the specified segment is executed. Function code B part function definition: select command mode. Single segment/ multi segment position mode: Part B of the position command type description: 1 Absolute position command: The motor running target position value is the given position command value. TargetPos = PosAbs. 2 Relative position command: The motor running target position value is the current actual position value plus the given relative position value. TargetPos = PosFdb + PosRel.

3 Incremental position command: motor running target position value is the previous position command value plus the current incremental position command value. TargetPos = PosCmd + PosInc. Speed mode: Part B function description: In the speed mode, the B part of the control word indicates whether the next Pr command value is automatically executed after the current speed command is reached. If the B part is 1, the next Pr command value is automatically executed. The next Pr instruction can be a single-segment, multi- segment position command, a speed command, or a jump command.

If part B is 0, the motor will continue to run at the speed value given by the current Pr until the next Pr instruction starts execution. Function code C part function definition: select the interrupt function. Interruption Description: When the interrupt function is enabled, it will switch to the next position command immediately, regardless of whether the current position command is running or not.

The 204 SD700 Series Servo Technical Manual Part B Single / multi-segment Speed mode Jump mode position mode 0 The current position command value is the absolute position value After the implementation of the current speed does not switch to the next Pr —— 1 The current position command value is the incremental position value The next segment of Pr is automatically executed after the current speed is executed —— 2 Current position command value is relative position value —— —— Part C Position mode Speed mode Jump mode 0 Interruption function is not enabled Interruption function is not enabled Interruption function is not enabled 1 Interrupt function enable Interrupt function enable Interrupt function enable