VEICHI — SD700 User Manual 20230516

margin of the current position command is accumulated to the next position command for position command planning. If the interrupt function is not enabled, it will switch to the next position value execution only after the current position command is completed. The plug-in function is shown below: Interrupt operation Uninterrupted operation Note: The interrupt function is valid after the Pr command is set, and the interrupt function is judged when the latter command is triggered. Function code D part function definition: select overlapping function Position overlap description:

After the overlap function is turned on, when the multi-segment position command is executed, when each position command is executed to the deceleration phase, it will not decelerate to 0, and the next position command will be directly planned from the current speed. If the overlap function is not turned on, after the current position command is 205 SD700 Series Servo Technical Manual Part D Single / multi-segment Speed mode Jump mode position mode 0 Overlap function does not turn on Target speed unit rpm —— 1 Overlap function on Target speed unit PPS ——