executed, decelerate to 0 and then plan the next position command. The overlap function works only in multiple positions, the single-segment position does not work, and the multi-segment position delay time becomes 0 after the overlap function is turned on. The multi-segment position overlap function is shown below: Rising edge Rising edge POS_T Trigger pulse POS Position increment Overlapping function execution T time waveform Rising edge Rising edge POS_T Trigger pulse POS Position increment No overlapping function execution T time waveform Note: When the overlap occurs, the previous instruction setting takes effect.
When the previous instruction runs to the deceleration point, it runs the next instruction. Note: In speed mode, this bit indicates the speed command unit. 206 SD700 Series Servo Technical Manual