267 SD700 Series Servo Technical Manual AL.901 Excessive position deviation warning during servo ON Set correct excessive position deviation value during servo ON. AL.910 Overload warning 1. Check if there is any problem of the motor wiring and encoder wiring. 2. Incorrect motor or driver selection. AL.911 Vibration warning 1. Reduce the motor speed or reduce the speed loop gain. 2. Set the moment of inertia ratio correctly. AL.920 Regeneration overload warning 1. Set the power supply voltage within the specification range. 2. Set resistance value and capacity correctly. 3. Replace the servo drive because of servo driver failure. AL.921 DB overload warning 1.
Reduce the servo motor command speed. 2. Reduce the rotary inertia ratio. 3. Replace the servo drive because of servo driver failure. AL.930 Battery under- voltage warning Replace the battery. AL.941 Parameter change warning needed to re-power off Power down the drive before restart it. AL.971 Under-voltage warning 1. Adjust the AC/DC power supply voltage to the product specifications. 2. increase the power capacity. AL.9A0 Servo overtravel 1. Connect the overtravel signal correctly. 2. Confirm the accuracy of the operating instructions of the host computer device.