*1.M-II type refers to the servo unit interface specification for MECHATROLINK-II communication command type *2.M-III type refers to the servo unit interface specification for MECHATROLINK-III communication command type Note: Pulse and CANopen servo is standard configured with 12 bit analog; ∆ is optional configuration; √ is standard configuration; Ч is not configured. Maintenance and Inspection of Servo Drive The servo system is made up of many parts. The equipment performs its functions only when all the parts work properly. In mechanical parts and electronic parts, some parts need to be maintained depending on the conditions of use.
It must be regularly checked or replaced according to the service-time to ensure that the servo motor and servo drive can operate normally for a long time. Inspection of Servo Motor Since the AC servo motor does not have the electric brush so that only a simple daily maintenance is required. The maintenance period in the table is a rough standard. Please judge and determine the most appropriate time for repair according to the conditions of use and use environment. Although the servo drive does not require daily inspections, it should be Inspection more than once a year.
Inspection of Servo Drive 23 SD700 Series Servo Technical Manual type Inspect items Inspect time The essentials of Notes inspection and maintenance Vibration and sound every day Tactile and auditory judgments No increase compared to usual Appearance overhaul According to the insult Erasing with a cloth or cleaning with an air gun - Insulation resistance measurement At least once a year Disconnect the servo system and measure the insulation resistance with a 500V megger Resistance value exceeding 10MΩ is normal When it is 10MΩ or less, please contact our maintenance department Replacement of oil seals At least once every 5,000 hours Please contact our agents or technical support Only servo motor with oil seal Comprehensive maintenance At least once every 20,000 hours or 5 years - Maintenance Inspect time The essentials of inspection Notes and maintenance Appearance maintenance At least once a year No garbage, dust, oil traces, etc Erasing with a cloth or cleaning with an air