Approximate Standards for Changing Internal Parts of Servo Drive Electrical and electronic parts are subject to mechanical wear and aging. To ensure safety, please do regular inspections. In addition, please refer to the following table for the standard number of years of replacement, and contact our agency or sales office. After the inspection, we will judge whether we need to replace the parts. The servo drive serviced by our company has its user parameters adjusted back to the factory settings. Be sure to reset the user parameters before use by yourself. Precautions during Operation and Running Operating Qualifications This product must be operated by trained professionals.
Moreover, the operator must be trained in professional skills, familiar with the installation, wiring, operation and maintenance of the equipment, and properly respond to various emergencies that occur during use. Safety instructions Warning signs are presented for your safety and are measures to prevent injury to the operator and damage to the product and associated systems. Please read this manual carefully before use, and strictly follow the safety rules and warning signs in this manual.
24 SD700 Series Servo Technical Manual gun Loose screws Wiring board, connector mounting screws and so on must not loosen Please tighten Parts’ name Standard replacement period Conditions of use Cooling fan 4 years～5 years Ambient temperature:annual average 30° C Load rate: 80% or less Operating rate: 20 hours or less/day Smoothing capacitor 7 years～8 years Relay According to actual use conditions Aluminum electrolytic capacitors on printed circuit boards 5 years Attention Install the machine and before starting operation, perform the switch and parameter settings appropriate to the machine.
If you operate the machine without setting, it may cause accidental operation, malfunction, or personal injury. Do not make extreme changes to the parameter settings. Otherwise, it may cause unstable operation, mechanical damage or injury. To avoid accidents, install a limit switch or stopper at the end of the movable part of the machine. Otherwise, it may cause damage or injury to the machine. The test run should be performed when the servo motor is fixed and disconnected from the machine. Otherwise, injury may occur.