15 Appendix 15.1 Compliance with Certification and Standard Requirements Product directive table 15.1.1 CE Certification Figure 15-1 CE certification mark ● "CE Marking" is a mark that indicates compliance with the Low Voltage Safety (LVD) and Electromagnetic Compatibility (EMC) Directives for commercial trade (production, import, and sale) in the European region. The CE mark is required for commercial trade (production, import, and sales) in the European region. ● This product complies with the Low Voltage Directive (LVD) and Electromagnetic Compatibility (EMC), and is labeled with the CE mark.
● Machinery and devices in which this product is installed must also meet CE requirements when sold in the European region. ● When the CE mark is affixed to the terminal where this product is installed, the responsibility shall be borne by the customer who finally assembles the product, and it is up to the customer to confirm that the machinery and devices of the final product comply with CE marking. 15.1.2 Conditions of Compliance with EMC Directive This product complies with the European EMC Directive 2014/30/EU and meets the requirements of the standard EN IEC 61800-3 and is suitable for both Type I and Type II environments.
In order to make this product comply with EMC Directive and standard requirements, it is necessary to install EMC filter on the input side of the driver and select the recommended shielded cable on the output side, and it is necessary to comply with the cabinet installation requirements to ensure 298 SD700 Series Servo Technical Manual Certification name Directive name Standard compliance CE certification EMC Directive 2014/30/EU EN IEC 61800-3 LVD Directive 2014/35/EU EN 61800-5-1 EN 60034