reliable grounding of the filter and reliable 360° lap of the output cable shield. Note: If used in a Type I environment, this product may cause radio interference. In addition to the CE compliance requirements mentioned in this chapter, the user should take measures to prevent external interference when necessary. 15.1.3 EMC Standard Introduction EMC (Electromagnetic Compatibility) refers to the ability of electrical and electronic equipment to work normally in an environment with electromagnetic interference, and the ability not to release excessive electromagnetic interference to other local equipment or systems so as not to affect the stable work of other equipment.
Therefore, EMC includes two requirements: on the one hand, it means that the electromagnetic interference generated by the equipment to the environment where it is located during normal operation cannot exceed a certain limit; on the other hand, it means the ability to work normally with a certain degree of immunity to the electromagnetic interference present in the environment, i.e. electromagnetic sensitivity. EN IEC 61800-3 defines the following two types of environments: ● Type I environment: Facilities that include civil environments and also include facilities that are directly connected to the low-voltage grid supplying power to civil buildings without an intermediate transformer.
● Type II environment: Facilities other than those directly connected to the low-voltage grid supplying power to residential buildings. The products are classified into the following four categories according to the intended use environment: ● Category C1 equipment: Electrical drive systems with a rated power supply of less than 1000V, used in the first environment. ● Category C2 equipment: The rated voltage of the electrical drive system is less than 1000 V. It cannot be plug-in equipment or removable equipment, and can only be installed and commissioned by professionals when used in the first environment. ● Category C3 equipment:
The rated voltage of the electrical drive system is less than 1000 V. It is suitable for the second environment, but not for the first environment. ● Category C4 equipment: The rated voltage of the electrical drive system is not less than 1000 V, or the rated current is not less than 400 A, or in a complex system suitable for the second environment. 15.1.4 Conditions of compliance with the LVD Low Voltage Directive This product has been tested in accordance with EU safety standard EN61800-5-1 and is confirmed to comply with the Low Voltage Directive.
The following requirements need to be met in order for the machinery and devices in which this product is installed to comply with the low voltage directive. Installation Site Please install this product in places with overvoltage level III and pollution level 2 or less as specified in IEC 60664-1. Installation Environment See " 1.4.4 Installation Environment Requirements" on page 16 for installation environment 299 SD700 Series Servo Technical Manual