2.1.2 Functions Switch Press the MODE/SET key, the function will be switched like this shown as below: MODE/SET setting Aux functions Monitoring Status display MODE/SET MODE/SET MODE/SET Parameters 2.1.3 Status Display The method of judging the status display is as follows: Display Means that the drive is ON. Flashing displays fault code, more details on the “fault code”. Means that the input signal(P-OT) is an No-motor testing function displays the running status open circuit. alternately, more details in this function. 33 SD700 Series Servo Technical Manual Meaning Di Means that the drive is OFF. splay Meaning Means that the input signal (N-OT) is an open circuit.
Display It l lig Sp ab P po To It l of Meaning Displ ights on when the control power is ON and hts off when OFF. ay It lights when It light eed control: speed outputs(/V-CMP) are solutely same. osition control: it lights on when the process sitioning is OK(/COIN). rque control: it lights on all the time. Torque control: it lights on when the torque command inputs. Position control: it lights on when the pulse clear signal outputs. ights on when the drive is OFF and lights f when ON.