VEICHI — SD700 User Manual 20230516

3.9 Digital Input Signal 3.9.1 Input Signal Descriptions 51 SD700 Series Servo Technical Manual Control Signal name Pin No.

Function number and Description mode Common /S-ON Allocated signal (38~46) 0x01 Signal to control servo motor ON/OFF ( power on/power off ) POT 0x02 Positive limit to stop the servo motor drive when the mechanical movement exceeds the movable range (overtravel prevention function) NOT 0x03 Negative limit to stop the servo motor drive when the mechanical movement exceeds the movable range (overtravel prevention function) /ALM-RST 0x04 Alarm Reset /P-CON 0x05 P action command, when the signal is ON, the speed control loop switches from PI (proportional, integral) control to P (proportional) control /TLC 0x06 Torque limit switching, used when the torque limit needs to be changed during operation /SPD-D 0x08 Used to change the direction of motor control at internal speed /SPD-A 0x09 When running in internal speed mode, it is used to select the internal speed command of the segment /SPD-B 0x0A /C-SEL 0x0B Control mode switching, when the control mode is mixed mode, used to switch the control mode /ZCLAMP 0x0C Zero fixed signal, used as zero fixed in speed mode /INHIBIT 0x0D Pulse input prohibition, used as disable pulse input count in position mode /G-SEL 0x0E Gain selection, when the gain is switched manually, it is used to switch the gain /PSEL 0x10 Command pulse input rate switching, used to switch pulse input rate signal in position mode +24VIN 47 Used when the control signal is input by control power Operating voltage range:

+11V ~ +25V ( +24V power supply should be provided by users.) SEN 4 Input signal requiring initial data when using an absolute encoder BAT+ BAT- 21 22 Spare battery connection pin for absolute encoder (Note) Do not connect the encoder cable with the battery unit when using Speed V-REF 5(6) Input speed command. Max. input voltage: ± 10V Position PULS /PULS SIGN /SIGN 7 8 11 12 Set any of the following input pulse patterns Symbol + pulse sequence CW+CCW pulse sequence 90° phase difference 2-phase pulse CLR /CLR 15 14 Clear position deviation during position control Torque T-REF 9(10) Input torque command, input voltage range: ± 10V