VEICHI — SD700 User Manual 20230516

3.12 Position Control Wiring Diagram OCP Differential com mand pulse *1 /PULS PULS Battery of absolute encoder 3.2V ~ 4.5V input (Max 4Mpps) /SIGN OCS SIGN CLR +24V +24VIN *2 /CLR A phase of encoder pulse division output B phase of encoder pulse division output Linear receiver: SN75ALS175 or MC3486 of T.I. company C phase of encoder pulse division output Control mode switch input (Valid while ON) /C-SEL Command pulse forbidden input (Valid while ON) /INHIBIT Servo ON input (Servo ON while signal ON) /S-ON P operation command input (P operates while ON) /P-CON Forbid FWD driving input (Forbid driving while OFF) /N-OT /P-OT Max voltage of optocoupler output : DC 30V Max current:

DC 50mA Forbid REV driving input (Forbid driving while OFF) Alarm reset input (Reset while ON) /ALM-RST Torque limit selection (According to torque limiting mode) /TLC FG shields are connected with connector shell. Frame ground *2. DC24V power should be prepared by user. And double insulation or reinforced insulation equipment should be used for DC24V power. *3. Connected while using absolute encoder. But never connect backup battery while using encoder cables with battery unit. *4. Output signal should be received by linear receiver. *1. is twisted shields. Note: while using 24V braker,DC24V power should be separated from the power for input and output signal (CN1).

Please prepare other power individually, otherwise, there may be misoperation of input and output signal while power on. ! If the input voltage of the linear drive input port is greater than 12V, please connect the appropriate current limiting resistor in series in the circuit, otherwise, the linear drive input port may be damaged. Cautions 63 SD700 Series Servo Technical Manual 1. 24V power, with built-in current limiting resistance. OCP /PULS OCS VDC 24V /SIOGCN 2. 12V~24V power, with external external current limiting resistance.

PULS R /PULS V D C SIGN 12V~24V /SIGN VDC R 1kΩ R ,1 /4W V RDC +- 61 8.5 10mA 2kΩ ,1/4W 12V 24V 1kΩ ,1/4W 2kΩ ,1/4W CN1 16 7 8 21 22 17 11 12 15 33 14 34 35 36 47 19 20 38 +15V 39 3 13 40 18 1 41 25 42 26 27 43 28 44 29 30 45 31 32 Connector shell BAT(-) /PPA AO O pA /PPB BO O pB /PP CC OO pC PL1 PL2 OC po comma PL3 SG Signal S- RDY+ Servo re S-RDY- while re COIN+ Position f COIN- (ON while /V- CMP+ The spee /V- CMP+ ON while ALM+ Servo al ALM- OFF whi